Service Routine - Whirlpool LCE4332PQ User Manual

SERVICE ROUTINE

To initiate the Service Routine, perform the fol-
lowing steps.
Setup
1. Make sure the washer is turned off while it
is plugged into a power outlet.
2. Disconnect the power supply cord plug
from the outlet and plug it back in.
3. Within 10-seconds of connecting the washer
to the electrical supply, simultaneously press
the WATER TEMPERATURE and WATER
LEVEL keypads. The MEDIUM WATER
LEVEL LED will remain on. NOTE: If the
LED is not on, repeat steps 1 through 3.
Last Error Display
• Simultaneously press the WATER LEVEL
and PROGRAM SELECTION keypads. The
display will show the last error that occurred.
LED Test
• Press the WATER TEMPERATURE keypad
and all of the LEDs should turn on.
Component Tests
NOTE: The "Component Tests" have four parts.
Press the PROGRAM SELECTION keypad to
advance the tests.
1. Press the PROGRAM SELECTION key-
pad. The "Heavy Duty" LED will light, and
the cold water inlet valve will be activated.
When the cold water reaches the Medium
level, the pressure switch will cause the
"Heavy Duty" LED to begin blinking.
2. Press the PROGRAM SELECTION key-
pad. The "Normal" LED will light, and the
hot water inlet valve will be activated. When
the hot water reaches the High level, the
pressure switch will cause the "Normal"
LED to begin blinking.
6-4