Removing The Brake Actuator Assembly - Whirlpool LCE4332PQ User Manual

REMOVING THE BRAKE ACTUATOR ASSEMBLY

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Tape the lid closed and lay the washer on
its rear panel so that you can access the
bottom of the unit.
Brake Actuator
4. Remove the capacitor clamp screw, and
remove the capacitor and clamp from the
motor support (see the photo at the top of
the right column). NOTE: Allow the ca-
pacitor to hang by its wires out of the way.
5. Disconnect the two wire connectors from
the brake actuator terminals.
6. Remove the two phillips brake actuator
screws from the motor support.
Actuator Wire
Connectors
4-16
Capacitor
Clamp Screw
Brake Actuator
Actuator
Screws