Whirlpool LCE4332PQ User Manual page 16

3. Squeeze the ears of the silver, double-
wire clamp with pliers to open it. Place the
clamp over the straight end of the drain
hose 1/4" (6 mm) from the end.
4. Open the clamp and twist the hose back
and forth while pushing down onto the
drain connector at the bottom of the washer.
Continue until the hose contacts the cabi-
net.
5. Place the clamp over the area marked
"CLAMP," and release the clamp.
1/4"
(6 mm)
C
A. Drain hose
B. Clamp
C. Cabinet
A
B
1/4"
(6 mm)
For standpipe or laundry tub drain systems
1. Open the yellow, single-wire clamp with
pliers, and slide it over the hooked end of
the drain hose to secure the rubber and
corrugated sections together.
2. Place the hooked end of drain hose into
the laundry tub, or standpipe. Rotate the
hook to eliminate kinks.
To prevent drain water from going back into the
washer:
• Do not straighten the hooked end of drain
hose.
• Do not force excess drain hose into the
standpipe. The hose should be secure, but
loose enough to provide a gap for air.
• Do not lay excess drain hose in the bottom of
the laundry tub.
• For floor drain installation, see kit number
required under "Alternate Parts" on page
2-2.
2-6
A
B
A. Hooked end
B. Drain hose