Complete Installation; Connect Washer - Whirlpool LCE4332PQ User Manual

ATTACH THE FAUCET ADAPTER KIT
Proper connection of your faucet adapter kit
will allow hot and cold water to enter your
washer properly. It also helps prevent water
damage due to leaks.
Attach the faucet adapter kit from the parts bag
to your faucet. A standard faucet adapter and
washer are supplied. Customized adapters are
available from traditional plumbing supply
sources.

CONNECT WASHER

1. Roll the washer to the sink area. The
wheels do not roll from side to side. Be
sure your washer is on a level floor to help
avoid movement during the spin cycle.
2. Attach the fill-and-drain hose connector to
a single-spout hot-cold water faucet. Move
the locking collar down while lifting the
connector until it snaps into place.
A
A. Red water-flow button
3. Set the water temperature for the wash
cycle by adjusting the hot and cold water
faucets.
To test the water, press the red water-flow
button on the hose connector. You may
need to adjust the water temperature for
the rinse cycle. Keep the Wash/Rinse
Temperature setting on your washer set at
Cold/Cold.
A
B
A. Washer
B. Adapter

COMPLETE INSTALLATION

1. Check the electrical requirements on page
2-3, and make sure that you have the
correct electrical supply and the recom-
mended grounding method.
2. Check to be sure that all the parts are now
installed. If there is an extra part, go back
through the steps to see which step was
skipped.
3. Check to be sure you have all of your tools.
4. Dispose or recycle all packaging materi-
als.
5. Check to be sure the water faucets are on.
6. Check for leaks around faucets and inlet
hoses.
NOTE: If the washer is attached to a faucet
equipped with a spray hose, the constant water
pressure may cause the spray hose to leak. To
prevent a possible failure, the spray hose should
be disconnected or replaced with a high-pres-
sure hose.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Read the "Washer Use."
2-11