Whirlpool LCE4332PQ User Manual page 38

b) Turn the suspension ball so the bend in
the rod is over the slot, and slide the
rod through the slot and the hole in the
cabinet gusset.
Turn Suspension Ball
& Remove Rod From
Slot & Gusset
c) Hang the end of the rods over the edge
of the tub, and tape them in place so
they do not fall off.
18. Partially lift the tub out of the washer
cabinet and remove the following items
from the sides of the tub:
a) Wiring (remove standoffs).
Wiring Standoff
Hang Rods On Tub
b) Pressure switch hose (remove stand-
offs & cut wire tie).
Pressure Switch Hose
c) Overflow hose (if present) and rubber
seal.
d) Four suspension rods and rubber snub-
ber straps.
Suspension Rod Assembly
Overflow Hose Seal
19. Remove the tub from the cabinet and
place it on its side on a plastic drop cloth,
then clean the excess grease off the tub.
4-10
Cut Pressure Switch
Hose Wire Tie