Control Guide; Power On/ Off; Control Panel Display; Control Panel - GBC TALON 44 Operation And Maintenance Manual

TOP 032 o F
o
BOT 032 F
Release
WAIT
TOP 032
BOT 032
Release
WAIT
Top Tem p.
B ottom Tem p.
Press/R elease
Rev.
22
Fig. 5
SPEED 03
JOB 01
Fig. 6
o F SPEED 03
o F JOB 01
Speed
Job
C ooling
Stop Run
Fig. 7

CONTROL GUIDE

A. POWER ON/ OFF: (Figure 5)
Located at the back left of the
machine applies power to the
laminator. The control panel display
will illuminate when position
marked "l" is pushed. The off
position, marked "O", removes
power from the laminator.
B. CONTROL PANEL DISPLAY:
(Figure 6) Illuminates when the
laminator is plugged in and POWER
ON/ OFF is in the on, (I), position.
Displays settings for top heater,
bottom heater, speed, Job, mode
and ready/wait/ positioning
indicator.
ROLLER POSITION INDICATOR:
Displays the current main roller
position. In figure 7, the roller is
shown in the "Release" position.
Refer to Roller Handle for more
information.
READY/ WAIT INDICATOR:
"READY" appears when actual
temperature is equal to (+/- 5) set
temperature. "WAIT" appears
when actual temperature is lower
than the set temperature. "WAIT"
appears when actual temperature
is higher than the set temperature.
POSITIONING INDICATOR:
"Positioning..." appears in place
of the ready/ wait indicator any
time the main rollers are traveling in
an upward or downward motion.
C. CONTROL PANEL: (Figure 7)
MASTER DIAL : Increases (+)
or decreases (-) the numeric value
for the selected setting when
turned. Press and hold the dial to
display actual temperature of top
and bottom main rollers.
Top Temp. : When pressed,
permits increasing or decreasing of
the top temperature by turning the
MASTER DIAL and is
indicated on the control panel
O O
display. Range is 32 F - 266 F (0
- 130 O C).
Bottom Temp. : When
pressed, permits increasing or
decreasing of the bottom tempera-
ture by turning the MASTER DIAL
and is indicated on the control
panel display. Range is 32 o F -
266 O F (0 O C - 130 O C).
I
O
C