•
Linkage recording: When alarm is triggered, the device SD card will be driven to
record images. The record files can be saved via E-mail sending or FTP uploading.
•
Motion Detection Area: Left click and drive the mouse to set the surveillance
areas (4 areas at most).
•
All: Set the whole video as motion detection area.
•
Clear: Clear all motion detection areas.
After setting all the parameters, click Save to make the parameters valid.
Sensor Setting
See Figure 3-37 for the interface of "Sensor Detection Setting":
Set sensor alarm parameters here: Enable detect, sensor type, deployment time, linkage
alarm output, linkage output duration, E-mail sending when alarm has been triggered,
linkage snapping/recording, etc.
•
Enable detect: Enable or disable sensor alarm detection.
•
Sensor type: NO and NC mode.
•
Deployment Time: Set the period of time for sensor alarm detection, two periods
allowed.
Record file packet time equals duration of alarm add the recocd
time setted in Linkage recording.
Figure 3-37
Honeywell
31