Honeywell HISD-1181W Operation Manual page 33

•
Storage Device Info:
View information of SD card here, including No., TotalSize, FreeSize and Status.
Users can also click Format button to format SD card, during the formatting
process, please click Refresh button to the display formatting completion
percentage.
•
Storage device record parameters
Code stream: Set record stream for SD card, preferred stream and alternate
stream are selectable.
Record file packet time: Set packing intervals for each segment of record file when
SD card is recording.1 means files will be packed every 1 minute.
•
Other Parameters
Overwrite old files when disk is full: When the storage capacity of SD card is used
up, the device will delete old files automatically. The way to delete old files: first
delete the files of the earliest date, if the space is still not enough, then delete the
files of the earliest date but one, then go on like this if necessary. If the record files
are taken on the current date, then first delete the files of the earliest hour. But
files of the current hour cannot be deleted, if the SD card gets full in one hour, the
device will stop recording and snapping images. After the one-hour session ends,
system will delete the files of the hour and continue to record and snap pictures.
Auto search the storage device when start: Check storage device or not when IP
camera starts.
After setting all the parameters, click Save to make the parameters valid.
Figure 3-33
Honeywell
27