Nikon coolpix L100 Repair Manual page 54

7-1-2. 【VR-MCU firmware update】
・ Insert the SD card, in which the firmware was copied, into the camera.
・ Turn the camera ON.
・ Set the mode dial to "AUTO" and turn the camera OFF.
・ While pressing the "MENU" button and setting the zoom lever to "W", turn the camera ON.
・ Turn the camera OFF.
・ Turn the camera ON again.
・ Only when the VR-MCU firmware update is necessary, the updating will start automatically.
If it is not necessary, the camera will start as normal.
!
Updating・・・
Warning
Do not turn camera off
during update!
・ "Done" (completion of updating) will be displayed and the camera will be turned OFF automatically.
・ Remove the SD card.
- A0 ･ L100 -
INC
VMA43007-R.3780.A
Done
PLEASE WAIT.