Nikon coolpix L100 Repair Manual page 53

7-1. Firmware update
When the main PCB is replaced, be sure to perform the firmware update to the latest (see 7-1-1) and the VR
MCU firmware update (see 7-1-2)
7-1-1. 【Firmware update】
・ Format the SD card on PC. Copy the latest firmware "firmware.bin" into the "firmware" folder.
・ Insert the SD card, in which the firmware was copied, into the camera.
・ Turn the camera ON.
・ Press the "MENU" [*] button of the camera, and select "Set up".
・ Select "Firmware version".
Set up
Menus
Welcome screen
Date
Monitor settings
Date imprint
Exit
・ Click "Yes" to perform the updating.
Note) Do NOT turn the camera OFF during updating.
Current
New
:L 1 0 0 V e r.X .X
Update to new firmware?
Exit
MENU
・ The message that indicates the completion "Done" appears, then turn the camera OFF and remove the SD
card.
・ Turn the camera ON to check "Firmware version".
・ Turn the camera OFF to end the procedure.
!
Done
Turn camera off to
complete upgrade.
Caution:
After finishing the firmware update, be sure to perform the VR-MCU firmware update on the next page,
too.
to the latest versions
:L 1 0 0 V e r.X .X
No
Yes
.
Set up
!
- A ･ L100 -
VMA43007-R.3780.A
Battery type
Protect
Rotate image
Copy
Firmware version
Exit
Updating・・・
Warning
Do not turn camera off
during update!
COOLPIX L100 Ver . X.X
Back
INC
LR6