Table of Contents
Advertisement
Appendix D
Using Your PC-DIO-24 (Non-PnP) Board
Specification
5 V supply fuse
Power-up state
Configuration
Base I/O Address
Hex 210 (factory setting)
1
2
3
4
U9
PC-DIO-24/PnP User Manual
Table D-1. Comparison of Characteristics (Continued)
Original PC-DIO-24
Nonresettable
No pullups or
pulldowns
The PC-DIO-24 contains one DIP switch and two jumpers to configure
the base I/O address, interrupt level, and interrupt enable signal.
Figure D-1 shows the location of DIP switch U9 and jumper
sets W2 and W3.
The PC-DIO-24 is configured at the factory to a base I/O address of hex
210, to use interrupt enable line PC4, and to use interrupt level 5. These
settings (shown in Table D-2) are suitable for most systems. However,
if your system has other hardware at this base I/O address, interrupt
enable line, or interrupt level, you need to change these settings on the
PC-DIO-24 (as described in the following pages) or on the other
hardware. Record your settings in the PC-DIO-24/PnP Hardware and
Software Configuration Form in Appendix E, Customer
Communication.
Table D-2. PC-DIO-24 Factory-Set Jumper and Switch Settings
Interrupt Enable Line
PC4 (factory setting)
W2: Row PC4
5
6
7
8
Revised PC-DIO-24
Self-resetting
Jumper for pullup
(factory default)
or pulldown
D-2
PC-DIO-24PnP
Self-resetting
Jumper for pullup
(factory default)
or pulldown
Interrupt Level
Interrupt level 5 selected
(factory setting)
W3: IRQ5
© National Instruments Corporation
Advertisement
Table of Contents
