Installation And Configuration; Installation; Figure 2-1. Jumper W1 Location - National Instruments PC-DIO-24/PnP User Manual

Installation and
Configuration

Installation

Note:
Note:
© National Instruments Corporation
This chapter describes how to install and configure the
PC-DIO-24/PnP.
Install your driver software before installing your hardware. Refer to your
NI-DAQ release notes for software installation instructions.
The PC-DIO-24/PnP uses 100 k
power-up. You can use jumper W1 to select whether data signals are pulled
up to Vcc (+5 VDC), factory default, or pulled down to GND. Figure 2-1
shows jumper W1. For more information, see the Digital I/O Power-up
State Selection section in Chapter 3, Signal Connections.
You can install the PC-DIO-24/PnP in any unused 8- or 16-bit
expansion slot in your computer. The following are general installation
instructions, but consult your computer user manual or technical
reference manual for specific instructions and warnings.

Figure 2-1. Jumper W1 Location

resistors for polarity selection at
2-1
Chapter
2
W1
PC-DIO-24/PnP User Manual