Asko TL751 XXLW Service Manual page 21

2-4. Operation of Buttons
1) Power
A. The electric power switch turns on/off the display.
B. Automatic switch off function
1 Power is immediately switched off after an operation is done.
2 Power is switched off after 10 minutes if no button is selected while power is on.
C. Initial display when power goes on
1 LED of all courses goes on in order.
2 "_ _ _" is displayed at 18:88 LED.
2) Start/Pause
A. Normal Course is operated if you press the button after switching on the power.
B. Operation starts after you select one of 11 automatic and program courses.
C. If you press this button while the unit is in operation, the on-and-off indicator goes on and the machine
stops. If you press the button again, the operation is resumed.
D. If you press Pause Button, other buttons or the encoder switch does not function. That is, you can not
change the operation once it starts unless switching off the power.
1 Power is immediately switched off after an operation is done.
2 Power is switched off after 10 minutes if no button is selected while power is on.
3) Dry Level
A. If you press this button, the following is displayed in order.
Normal-More Dry-Very Dry-Damp Dry-Less Dry-Normal
B. Each level targets humidity as follows.
Dry Sensor
Damp Dry
Less Dry
Normal
More Dry
Very Dry
C. You can select all levels in Sensor Dry Course but none in Manual Dry Course.
Initial humidity
89
94
100
100
100
20
Target humidity
85% ~ 93%
91% ~ 98%
96% ~ 105%
100% or higher
100% or higher