Panasonic GP-KH232CUE Operating Instructions Manual page 32

[FILE LABEL] Puts a label name instead of a scene file number.
Characters (label) are displayed instead of the scene file number that is displayed on the screen
when the [SCENE] button on the front face of the CCU is pressed. Up to 16 alphanumerics and
symbols can be used to create a label. The created label is displayed in "LABEL" on the "SCENE
FILE" screen. Follow the procedure below to specify the label.
"SCENE FILE" screen
** SCENE FILE 1 ** P2
LABEL: ................
FLARE COMP
DNR
MATRIX
CHROMA GAIN ..
TOTAL PED
FILE LABEL
AWC MEMORY
RET END
Step 1
Set "FILE LABEL" to "ON" and press the [SEL]
button.
The title creation screen appears.
Important:
• When "FILE LABEL" is set to "OFF", a
label is not displayed even if the label is
created.
Note:
• Even when "FILE LABEL" is set to "OFF",
pressing the [SEL] button allows the label
creation screen to appear.
• A label can be created for each scene file.
Step 2
Move the cursor to the target character by
pressing the [g], [h], [e] and [f] buttons,
and press the [SEL] button.
The entered characters are displayed in
the editing area.
32
OFF
LOW
*USER
...... 38
|
........ 77
|
*OFF
1
Label creation screen
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
← →
SPACE
RET END RESET
................
Editing area
<Character entry>
• To revise a character, move the cursor to
" " or " " and press the [SEL] button.
Move the cursor to the character to be
revised in the entry range and reenter a
correct character.
• To enter a blank, move the cursor to
"SPACE" and press the [SEL] button.
• To delete all the entered characters, move
the cursor to "RESET" and press the [SEL]
button.