Panasonic GP-KH232CUE Operating Instructions Manual page 12

!4 HDMI output connector [HDMI]
This connector is used to connect to an
HDMI-ready monitor.
!5 RGB/YPbPr output connector
[RGB/YPbPr]
This connector provides the RGB signal
(red, green, and blue) output or the YPbPr
signal (luminance, color difference B, and
color difference R) output. The output sig-
nal can be set up with use of "OUTPUT
SEL" in the SETUP menu. (☞ Page 25)
The connector also provides G/L OUT sig-
nal and G/L IN signal can be input into the
connector.
(D-sub 9-pin connector, female)
5
9
Pin No. Signal
1 GND
2 GND
3 R, Pr
4 G, Y
5 B, Pb
6 G/L OUT
7 G/L IN
8 GND
9 Open
!6 S-video output connector [S-VIDEO]
This connector provides the luminance
signal (Y) output with synchronizing sig-
nals and color signal (C) output.
12
1
6
!7 Remote terminal [REMOTE]
This port is used to perform external con-
trol. (ø3.5 mini jack, 3-pole, serial)
Circuit diagram:
GND
RXD
TXD
!8 12 V DC power terminal [DC 12V IN]
This connector is used to connect an
external DC power supply of 12 volts
(1.2 A or more).
(DC jack type: EIAJ RC-5320A voltage
class 4)
Polarity:
!9 Cable clamp
This clamp is used to hold the 12 V DC
power cable.