Elc Setting [Elc] - Panasonic GP-KH232CUE Operating Instructions Manual

Step 3
Move the cursor to "POSI" and press the [SEL]
button after title entry.
The display positioning screen appears
and the entered camera title blinks.

2. ELC setting [ELC]

Setting ELC (electronic light control) to ON provides automatic adjustment of the screen brightness.
The convergence level of ELC can be specified at "BRIGHTNESS" in the SEL menu (☞ page 37).
If bright light such as a spotlight is present in the background behind a subject, the subject may
appear dark. To eliminate this phenomenon, masking bright areas allows users to perform backlight
compensation to hide bright areas.
Top screen of SETUP menu
** SET UP **
CAMERA ID
ELC
SHUTTER
GAIN
SENS UP
OUTPUT SEL
HDMI OUTPUT
SD ASPECT
END
Step 1
Set "ELC" to "ON" and press the [SEL] button.
The "ELC CONT" screen appears.
Step 2
Move the cursor to "AREA" and use the [e] or
[f] button to select an area.
The area is selectable from the following:
* The detection areas shown in the drawings
below are not displayed.
ALL (default): The detection target is the
whole area on the screen.
22
P1
*OFF
*OFF
OFF
OFF
OFF
RGB
YPbPr(422)
SIDE CUT
Step 4
Use the [g], [h], [e] and [f] buttons to
decide the title position, and hold down the
[FREEZE MENU ] button for 2 seconds or
more.
The display position is determined and the
title creation screen appears again.
"ELC CONT" screen
** ELC CONT **
AREA ALL
.... .... 4
PEAK/AVE |
P
RET END
S CIRCLE: The detection target is the
small circle area in the center of the
screen.
M CIRCLE: The detection target is the
medium circle area in the center of
the screen.
A