Setting The Language; Installing The Memory Backup Batteries - Royal 240DX Instruction Manual

Hide thumbs Also See for 240DX:
Table of Contents

Advertisement

Setting the Language

Installing the Memory Backup Batteries

Royal 240DX User's Guide
At the prompt, you can select English, Spanish, or French. Changing the language
changes the factory programmed words you and the customer see on the displays.
However, changing the language does not translate any words you program in the
cash register, such as PLU descriptions, header information, and so on.
Note
If you start programming the cash register and then change the language
midway, you will lose all of your previous programming.
To set the language
1 When you first turn the register on, you are prompted through all setup options.
Setting the language is the first option.
2 Select the language you want and press the CASH/Enter key. The language your
cash register shows on the operator display is set.
Your cash register uses 2 AA 1.5 volt batteries for the memory backup system. These
batteries did not come with your cash register and you must purchase them
additionally.
Caution
If you put the batteries in the cash register first, they can damage your cash
register. Put the batteries in when you are prompted.
1 At the prompt, open the Journal Compartment Cover.
Remove the Journal Compartment Cover and set aside.
2 Move the paper roller bar up and out of the way. Grab
the small handle on the right of the print roller bar. Push
the little handle towards the back of the cash register
and raise the paper roller bar
up. You see a slope down to the paper compartment. The battery cover is located
under the print roller bar, on the slope.
3 Remove the battery cover. Press the edge at the top of
the cover and push to the back. The cover pops off.
• Put the batteries in the slots. Make sure that the
positive and negative ends are in the right place. The
batteries have a little plus (positive) and minus
(negative) sign on each end to help you.
• Replace the battery cover. Slide the bottom tabs into
the long slit in the bottom position and snap the cover
into place. Do not put the tabs in the 2 holes in the
bottom of the compartment. The cover will not close
and you will break the tabs.
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents