Samsung OfficeServ 7100 Installation Manual page 99

Home Page Table of Contents
OfficeServ 7100 INSTALLATION
TECHNICAL MANUAL PART 8 MAY 2010
Figure 8.2 iDCS 18 Button Line Key Default
NOTE: Other types of iDCS, DS and ITP/SMT-i phones can be connected however the line
keys will have a different default button configuration.
Once the OfficeServ 7100 system is booted, the MP10/MP10a card verifies the cards mounted
on each slot and saves this information as the default configuration of the system. At default,
the OfficeServ 7100 system assigns 3 digits to CO lines, extensions, and extension groups.
Refer to Section 3. Installing and Replacing cards of this manual for details on switch 2.
CO line numbers from 701 through 7XX are sequentially assigned (by default) to the first CO
line card installed in the system from left to right and following numbers are continuously
assigned to the next CO line card of the next slot.
Extension numbers from 201 through 2XX are sequentially assigned to the first station type
card mounted in the system from left to right (starting from 4DLM if mounted on the
MP10/MP10a) and following numbers are continuously assigned to the next extension card of
the next slot. This numbering process continues until the extension numbers are assigned to
all extensions.
8.5