Table 7.3 Installation Tool Specification - Samsung OfficeServ 7100 Installation Manual

OfficeServ 7100
TECHNICAL MANUAL
Platform
CPU
OS
Main Memory
Hard Disk
CONNECTING INSTALLATION TOOL (OIT) TO LAN PORT
The OIT application can communicate to the OfficeServ 7100 system via the LAN or MODEM
connection. The OIT can connect to the MP10/MP10a via LAN connection using a customer
provided LAN switch or using the 4SWM module as shown in
• Set up the MP10/MP10a LAN parameters in MMC 830.
• If an MP10/MP10a is behind a firewall and the OIT is outside the firewall, ports 5090 and
5003 must be open to the private IP address of the MP10/MP10a.
MP10/MP10a (4SWM)
Detail procedures for each of the steps above are as follows:
SETTING NETWORK PARAMETERS THROUGH MMC 830
Set the network parameters of the system. Contact the network manager when setting values
for the network parameters.
1) Set the IP address of the system.
2) Set the subnet.
3) Set the gateway address.
4) Reset the MP10/MP10a.

Table 7.3 Installation Tool Specification

Category
Figure 7.24 OIT Connection to LAN Port
7.27
Home Page
Specification
IBM PC
Pentium III or higher
Windows 2000 or higher
64Mb or higher
1Gb or higher
Figure 7.24.
Table of Contents
INSTALLATION
PART 7 MAY 2010