Table of Contents
Advertisement
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
F I R E A L A R M
FIRE
F I R E T R O U B L E
FIRE TBL
SYS/TBL
F I R E P R O T E C T I O N
Fire-Zone Alarm
If a fire is detected, "FIRE ALARM" will be displayed and the keypad sounder will pulse.
1.
If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
2.
Press the
C
button to silence the keypad sounder.
3.
If there is no evidence of a fire, enter your User Code and press
alarm.
4
Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light will
be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing
NOTE: When the Fire Zone is reset, the FIRE icon on the left side of the display will go
out. If the FIRE icon is still displayed, the fire zone has not been properly reset. If you
cannot clear this condition by pressing
Fire-Zone Trouble
1.
If a problem in the fire-circuit is detected, "FIRE TROUBLE" will display and the
sounder will pulse to signal a malfunction.
2.
Press
to silence the sounder. Call for service immediately!
C
C
again will reset the keypad within about 10 seconds.
C
, call for service.
J
to turn off the
11
Advertisement
Table of Contents
