Fire Protection - NAPCO GEM-K1VPS Operating Manual

(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
F I R E A L A R M
FIRE
F I R E T R O U B L E
FIRE TBL
SYS TBL
20
F I R E P R O T E C T I O N
Fire-Zone Alarm
Silence method:
There are two ways to silence a fire alarm: (1) by pressing C only or (2) by entering your
U
User Code and pressing
keypad sounder will pulse. In addition, the "FIRE" icon will flash indicating the siren is on.
1.
If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire
Department from an outside phone.
2.
If there is no evidence of a fire, press C (or enter your User Code and press
off the alarm.
3.
Check smoke detector(s); if tripped, its red alarm indicator light will be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector;
etc.), pressing C again will reset the keypad within about 10 seconds. NOTE: When the Fire
Zone is reset, the FIRE icon on the left side of the display will go out. If the FIRE icon is still
displayed, the fire zone has not been properly reset. If you cannot clear this condition by
pressing C, call for service.
Fire-Zone Trouble
1.
If a problem in the fire-circuit is detected, "FIRE TROUBLE" will display and the sounder will
pulse to signal a malfunction. The "FIRE TBL" icon will display, and the "SYS TBL" icon will
flash.
2.
Press C to silence the sounder. Call for service immediately!
PRESS RESET ONLY
. If a fire is detected, "FIRE ALARM" will be displayed and the
USER CODE + ENTER
U
) to turn