Fire Protection - NAPCO Gemini GEM-TOUCH K Series Operating Manual

(Applicable only where local ordinances permit use of this alarm system for fire protection).
Fire-Zone Alarm
If a fire is detected, the alarm will sound, the zone number will appear on the keypad, the keypad sounder will pulse
and the keypad "fire" icon (shown at left) will flash.
• If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire Department from an
outside telephone. If there is no evidence of a fire:
• If the system is disarmed, at the Home screen, tap Arm, enter your User Code and tap Enter to silence the
alarm.
• If the system is armed, at the Home screen, tap Disarm, enter your User Code and tap Disarm to silence
the alarm.
• Check the smoke detector(s). If a smoke detector tripped, its red alarm indicator light will be on.
• After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector; etc.), at the
Home screen tap/hold-down Reset and enter your User Code and tap Enter to reset the system. Note: This
reset process may take up to about 10 seconds to complete.
Fire-Zone Trouble
• The system is constantly monitoring the fire zone(s) to ensure they are in good working
order.
• If a problem on a fire zone is detected, a system trouble E-41-NN will flash on the keypad,
followed by the number of the fire zone in trouble ("NN"). The sounder will activate and the
TROUBLE icon will flash on the keypad.
• At the Home screen, tap/hold-down Reset, enter your User Code and tap Enter to silence
the sounder. Call for service immediately!
12
F I R E P R O T E C T I O N
(TROUBLE Icon)
GEM-TOUCH K Style Keypad Operating Guide