NAPCO Gemini GEM-DXRP1 Operating Manual page 17

R E S E T
S Y S T R B L Y / N
R E S E T
S E N S O R M S G Y / N
S T A R T
E X I T T I M E Y / N
K E Y P AD F U N C T I O N S
Reset System Trouble? System troubles display and sound at the keypad. Correcting
the trouble will clear most indications, however the following error codes will require
manual reset: E13; E19; E20 and E22. (See SYSTEM TROUBLE ERROR CODES for a
description of error codes.)
Reset Sensor Watch Failure? (Sensor Watch programmed?
Your system may have been programmed for Sensor Watch, a feature which
supervises the motion sensors in the system. If a Sensor Watch failure occurs, a
System Trouble E22-NN will result, where NN represents the zone number of the
sensor in question. To reset, press
Menu, scroll to "RESET SENSOR MSG" and press D .
problem, call for service.
panels only).
Start Exit Time? (Optional) (Start Exit Time programmed?
In Commercial Burglary systems, exit delay may have been programmed to start after a
central-station "ringback" (verification) signal has been received. If the ringback tone
has not been received within about 30 seconds after arming, a communication problem
may exist. Use this function to start exit delay manually, then exit the premises
immediately. Be sure to have your alarm specialist check communications with the
central station as soon as possible.
P3200 control panels only).
to clear the display, enter the Function
C
(Note: This function available with GEM-P9600 and GEM-P3200 control
(Note: This function available with GEM-P9600 and GEM-
YES NO).
If you cannot correct the
YES NO)
17