Fire Protection - NAPCO iSecure ISEC-WL-KEYPAD Operating Manual

(Applicable only where local ordinances permit use of this alarm system for fire protection).
08
41
12
F I R E P R O T E C T I O N
Fire-Zone Alarm
If a fire is detected, the Hub red FIRE light will flash, the ISEC-WL-KEYPAD will flash the word
FIRE (along with the zone number) and the keypad sounder will pulse.
 If a fire is in progress, evacuate the premises immediately!
Department from an outside telephone.
 If there is no evidence of a fire, enter your User Code and press ENTER to silence the alarm.
 Check the smoke detector(s). If a smoke detector tripped, its red alarm indicator light will be
on.
 After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector;
etc.), pressing RESET will reset the keypad within about 10 seconds.
F
ire-Zone Trouble
 The system is constantly monitoring the fire zone(s) to ensure they are in good working order.
 If a problem on a fire zone is detected, a system trouble E-41-NN will display, followed by the
number of the fire zone in trouble ("NN"). The sounder will activate and the TROUBLE icon
will appear.
 Press RESET to silence the sounder. Call for service immediately!
If necessary, call the Fire