Fire Protection - NAPCO GEM-K3DGTL Operating Manual

(Applicable only where local ordinance permits use of this alarm control panel for fire protection).
NN
INTERIOR BYPASS FIRE/TBL SYS TBL
E
INTERIOR BYPASS FIRE/TBL SYS TBL
41
INTERIOR BYPASS FIRE/TBL SYS TBL
NN
INTERIOR BYPASS FIRE/TBL SYS TBL
F I R E P R O T E C T I O N
Fire-Zone Alarm
If a fire is detected, the FIRE/TBL light will flash with the zone number and the keypad
CHIME
sounder will pulse.
• If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
• If there is no evidence of a fire, enter your code and press
• Check the smoke detector(s). If a smoke detector tripped, its red alarm indicator
light will be on.
• After the alarm condition is corrected (thermostat cooled down; smoke cleared from
detector; etc.), pressing
seconds.
F
ire-Zone Trouble
• The system is constantly monitoring the Fire Zone(s) to insure they are in good
CHIME
working order.
• If a problem on a Fire Zone is detected, a system trouble E41 will display, followed by
the number of the Fire Zone in trouble. The sounder will activate, the SYS TBL light
CHIME
will come on.
• Press the
C
Note: Trouble Error Code E41 will only display for the GEM-P1664/P1632 & P816
CHIME
control panels.
again will reset the keypad within about 10
C
button to silence the sounder. Call for service immediately!
U
to silence the alarm.
11