Turning Off The Alarm (Disarming) When Returning - NAPCO Gemini GEM-DXRP1 Operating Manual

Napco gem-dxrp1 keypad operating guide
Hide thumbs Also See for Gemini GEM-DXRP1:
Table of Contents

Advertisement

T U R N I N G O F F T H E AL AR M ( D I S AR M I N G ) W H E N R E T U R N I N G
D I S A R M S Y S T E M
E N T R Y T I M E X X X
I N V A L I D E N T R Y
T R Y A G A I N
* * * *
A L A R M
0 2 - B A C K D O O R
0 3 - L I V I N G R O O M
If an intruder forces you to disarm your system, enter your Ambush Code and press
(1) A 2-digit code (prefix) entered just prior to your normal User Code and (2) A separate and unique User Code.
Example Type 1 (Prefix): If your User Code is 1234 and your Ambush Code is 99, press
Example Type 2 (Unique): If your User Code is 1234 and your Ambush Code is 8899, press
Using your Ambush Code will send a silent alarm to the central station. The red ARMED light will go out and the window will display "SYSTEM
READY" as if the system were normally disarmed. There will be no indication that a silent alarm has been sent.
10
Disarming the System
1
Enter your premises through the Entry/Exit door. The keypad will sound a steady or pulsing
tone to remind you to disarm the system before your Entry Delay time expires.
2
Enter your User Code and press
system has been disarmed. If you enter an invalid code, the keypad will beep 4 times,
signifying an error. Re-enter your code immediately. 10 seconds before Entry Delay expires,
the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alarm
* * * *
If the red ARMED light is flashing and "ALARM" is displayed, an alarm occurred while you were
out. Proceed with caution! If you suspect that an intruder may still be on the premises, leave
immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
1 Enter your code and press
to display "ALARM" followed by the zone(s) violated.
2 To reset the display, note the zones violated, then press
Ambush
(Optional) Your Ambush Code Type is:
My Ambush Code is ___________________
D.
The red ARMED light will go out, indicating that the
J
. After the system is disarmed, the window will continue
TYPE 1 (Prefix)
J.
There are two types of Ambush Codes:
991234
8899
.
C
TYPE 2 (Unique)
J.
J

Advertisement

Table of Contents
loading

Table of Contents