Table of Contents
Advertisement
User Program Mode
Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm
the system, but also to enter the User Program Mode, where you can program other User Codes, Zone Descriptions and also
set the system Time and Date. The following explains how you will use this code to program or erase additional User Codes:
A C T I V A T E
P R O G R A M
E N T E R U S E R C O D E
1 2 3
E N T E R U S E R C O D E
E N T E R U S E R C O D E
4 5 6 7
Note: The GEM-X255 panel will display
users in 3 digits, for example:
0 0 1
4 5 6 7
22
P R O G R AM M I N G ( O P T I O N A L )
Enter the User Program Mode
1. Enter your User Code, then press
Y / N
2. Answer NO until "ACTIVATE PROGRAM Y/N" is displayed, then press YES. "ENTER USER
CODE" will display indicating that the system is ready for User Code programming.
Programming / Reprogramming a User Code
1. Enter the digits of the user number to be programmed, followed by
-
-
for User 4, enter
2. Enter the new User Code (up to 6 digits)
D
3. Press
-
-
Code entered in the LCD Window will erase when
Repeat Steps 1 through 3 for each User Code to be programmed.
Erasing a User Code
1. Enter the digits of the user number to be erased followed by
-
-
2. Press
G0
•
Example: Erase User 3's 4-digit User Code:
-
-
•
Press
0 3AAG0G0G0 G0
A
04 AA
to save the new User Code. Duplicate Codes are not allowed; therefore a duplicate
to erase each digit of the User Code and then press
to enter the Function Mode.
AA
).
D
is pressed.
AA
. (Example:
.
D
.
J
.
Advertisement
Table of Contents
