Weber Spirit E-210 Owner's Manual page 8

1)Turn the LP cylinder so the o pening ofthe valve iseither tothe front, side o r rear of
the W eber egas b arbecue. Lift and h ook the cylinder onto the fuel gauge.
2)Loosen the cylinder lock wing n ut, Swing the cylinder lock down. Tighten the w ing
nut.
To Connect the hose
to the cylinder:
3) Remove the plastic dust cover from the valve.
4) Screw the regulator coupling onto the tank valve, clockwise, or to the right.
Hand-tighten only.
Note: This is a new type of connection, tt tightens clockwise and will not allow gas to
flow unless the connection is tight. The connection requires tightening by hand only.
/k WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
5) Mix soap and water.
6) Turn on the cylinder valve.
7) Check for leaks by wetting the fitting with the soap and water solution and watching
for bubbles. If bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and
recheck with the soap and water solution.
If leak does not stop, Contact the Customer Service Representative in your area using
the contact information on our web site. Log onto www.weber.com ®. Do not use the
barbecue.
8) When leak checking is complete, turn gas supply off at the source and rinse
connections with water.
REMOVE CONTROL PANEL AND BURNER CONTROL KNOBS
You will need: Phillips screwdriver.
1) Remove control knobs.
2) Remove screws with a Phillips screwdriver
3) Pull up igniter button until it sticks in the up position and remove control panel from
grill.
4) Replace control panel when Leak Check is completed.
CHECK FOR GAS LEAKS
!k DANGER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for leaks, Sparks or open flames will result in a fire or
explosion, which can cause serious bodily injury or death
and damage to property.
z_ WARNING:You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been flame-tested. As a safety precaution however, you should recheck
all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may
loosen or damage a gas fitting.
z_ WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled,
You will need: a soap and water solution, and a rag or brush to apply it.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
Make sure side burner is off.
To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel
counterclockwise.
WARNING: Do not ignite burners when leak checking.
Check for leaks by wetting the connections with the soap and water solution and
watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
SPIRIT E/SP-
210 & 310
_!i!i!i!i!i!i!i!i!ii!ii!ii!