Installation Of Indoor Unit - Toshiba RAS-M10SMUV-E Service Manual

Indoor unit
Hide thumbs Also See for RAS-M10SMUV-E:
Table of Contents

Advertisement

2
SELECTION OF INSTALLATION PLACE
Install the air conditioner certainly to sufficiently withstand the weight.
If the strength is insufficient, the unit may fall down resulting in human injury.
Perform a specified installation work to guard against an earthquake.
An incomplete installation can cause accidents by the units falling and dropping.
Remote controller
• Should be placed where there are no obstacles,
such as curtains, that may block the signal
• Do not install the remote controller in a place ex-
posed to direct sunlight or close to a heating source
such as a stove.
• Keep the remote controller at least 1m away from
the nearest TV set or stereo equipment.
(This is necessary to prevent image disturbance or
noise interference.)
• The location of the remote controller should be
determined as shown below.
3

INSTALLATION OF INDOOR UNIT

The installation of the air conditioning unit must be positioned in a location that can sufficiently support its
weight and give protection against adverse environmental conditions.
Failure to do so may result in unit damage and possible human injury.
Any incomplete installation may also cause possible risk of human injury.
• Unpack the package, take out the product and then place it on the floor so that the same surface directs
underneath as it is placed in the package.
• Never put the products in a pile or put weight on them, which are taken out from the packing box;
otherwise there is a possibility to damage electric parts, fan parts, draining mechanism, and etc.
If the both sides are turned over, a deformation of
mounting metal of the ceiling panel which is sold
separately, etc. may be caused.
Accordingly the product may be damaged and the
installation becomes impossible in some cases.
Strictly comply to the following rules to prevent damage of the indoor units and human injury.
• Do not place heavy objects on the indoor unit. (Even when units are still packaged)
• Always carry the unit as packaged from the factory wherever possible.
If carrying in the indoor unit unpacked by necessity, be sure to use buffering cloth, etc. to prevent damaging
the unit.
• To move the indoor unit, hold the hanging brackets (4 positions) only.
Do not apply force to other parts (refrigerant pipe, drain pan, foamed parts, or resin parts etc.).
• To be carried by two or more people. Do not strap the unit in positions other than stated.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
WARNING
WARNING
REQUIREMENT
– 45 –
www.heronhill.co.uk
Sensor part
Ceiling panel
Signal-receiving range
OK
Ceiling panel
base
Remote
controller
NO GOOD
Fax: 01823 665807

Advertisement

Table of Contents
loading

Table of Contents