Settings For Reception; Print Settings - Muratec F-320 Operating Instructions Manual

Settings for reception

Print settings

You can set three parameters for printing received fax messages:
• Print reduction rate
• Reduction margin
• Paper save function
You set all three in the same procedure, discussed on next column. Following is a
explanation for each:
Print reduction rate
Print reduction lets you set the machine to reduce large incoming documents to a
size that fits the paper in your machine. (This setting doesn't affect copies you may
make with your machine.)
Below are the options for the print reduction rate for fax reception:
Setting What it does
Automatically reduces printouts at variable rates down to a
minimum of 50%. Tries to reduce printout to fit on one sheet of
Auto
your selected paper size. If it can't, print the image at 100% size
on two or more pages.
Does not reduce documents. (Due to the sender's
100%
two pages when receiving a one-page fax document.)
Reduction margin
Your machine's reduction margin is measured in millimeters (mm). We'll define
reduction margin by explaining how it's used:
When a fax message enters your machine's electronic brain, the machine measures
the message's length and compares it to (a) the length of your selected paper (not
include the print margins) plus (b) the reduction margin you set. If the length of
the incoming message is shorter than (a) and (b) put together, your machine prints
the message on just one sheet.
If it's longer, your machine prints the message on more than one sheet.
Note: An Auto reduction setting and a reduction margin setting of 40mm will
print most incoming faxes as single pages. Try this combination first and
then, only if you have problems with it, select different settings.
Half-page reception
Half-page reception can conserve paper if some of the faxes you receive are half-
page, "memo-sized" messages. When activated, this feature tells the machine to
combine two of these half-page receptions onto a single sheet. Half-page reception
only combines half-page messages sent back-to-back during the same transmission.
It won't combine two half-page faxes from separate transmissions.
To adjust the print settings
Default setting: Rx reduction rate: Auto, Reduction margin: 40 mm,
1
Press
fax reception:
Rx Reduc.Rate
2
Press
3
Press
Margin
(00-85)
, this may print
TTI
4
Use the numeric keypad to enter the reduction margin you want. If
necessary, press
5
Press
half-page reception:
Half Page Recpt.:Off
6
Press
7
Press
Half-page reception: OFF.
, 2, 2, 0, 2, . The shows the current reduction rate for
MENU ENTER LCD
:Auto
$ $ # #
/ /Enter
or until the reduction setting you want appears.
to save the setting. The shows the current reduction margin:
ENTER LCD
40 mm
or to move the cursor.
to save the setting. The shows the current setting for
ENTER LCD
$ $ # #
/ /Enter
or until the setting you want appears.
to save the setting.
ENTER
Changing the default settings
4.3