Muratec F-320 Operating Instructions Manual page 117

Just in case ...
What you see on the
LCD
Document Jam
ContStor Enter/Cancl
Document Stored
Enter No. (0-32)
Enter No. (000-255)
Feeder In Use
Hang Up Phone
In Relay Box
In Secure Box
In Use in P OneTouch
Invalid I.D. Code
5.6
What it means/What to do
An original document jam while you are using
the ADF for either faxing or copying. See page
5.1 for instructions on clearing the jam.
You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
You tried to enter a call group number greater
than 32. Your machine can maintain 32 call
groups, numbered 1-32 (call group 0 covers all
the groups). Determine the correct call group
identifier number and enter it, instead.
If the optional NIC (network interface card) is
attached to your machine, and you tried to enter
a TCP/IP address greater than 255.
Enter the correct TCP/IP address.
The command you're trying to enter requires the
use of the , which is already in use. Wait for
ADF
the machine to stop using the , then try
ADF
again.
The optional handset is off-hook.
Hang it up, making sure the upper part of the
handset presses down on the "hook" button.
You tried to store a document for polling in an
F-Code box which is set to be a relay box.
Select an F-Code box which is set to be a bulletin
box, then try again.
You tried to store a document for polling in an
F-Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
You tried to erase the F-Code box or Batch box,
which is programmed in the programmable one-
touch key.
Erase the programmable one-touch key that con-
tains the F-Code box or Batch box you want to
erase, then try again.
The F-Code box . . code you entered isn't valid.
I D
Try re-entering your F-Code box . . code.
I D
What you see on the
LCD
Invalid Number
Invalid Passcode
Line Busy
Macro In Use
Memory Overflow
Start Or Cancel
No Command
No Department Code
No Document Stored
No Drum
What it means/What to do
You pressed a key which has no function during
the current operation.
The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protec-
tion passcode.
You tried to erase a document which someone is
polling from your machine. Wait for the fax to
complete the polling operation, then try again.
You tried to change the function for a Soft key,
but that Soft key has been programmed in a
Macro key. You cannot change the Soft key func-
tion until erase the Macro key that contains the
Soft key you want to change. Erase the Macro
key, then try again.
During transmission (or copying), you tried to
enter more pages into memory than your fax
could store. Press to tell your fax to keep
START
as many pages in memory as possible, or press
to delete from memory all pages stored
CANCEL
during this operation (but not previous opera-
tions).
You pressed . /
COMM CANCEL CONFIRM
upcoming commands, but your fax machine had
none stored.
You tried to turn on the department code setting
but there are no department codes stored in
your fax machine. Store at least one department
code, then try again.
. . . or . . .
You entered incorrect department code at fax
sending while the department feature is on.
Enter correct department code.
You tried to print a document from memory, but
your fax machine had none stored.
The drum cartridge is missing or has not been
properly installed in your fax machine.
Please properly install the drum cartridge.
. to review