Panasonic WV-CS850B Service Manual page 21

4.3.2 Starting E.V.R. Adjustment Program
8 Insert new floppy disk containing DOS Operating System
and the E.V.R. Adjustment Program into IBM PC/AT and
turn on the IBM PC/AT.
8 At the prompt, type RADJ2 CS85BETL and press the
ENTER key, then the initial menu page as shown in Fig. 4-
3-3 will be displayed.
PANASONIC REMOTE EVR ADJUSTMENT SYSTEM
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
M E N U
1. PAN/TILT POSITION-1
2. PAN/TILT POSITION-2
3. TILT RE-ADJ
4. PAN/TILT POSITION-1
5. PAN/TILT POSITION-2
<CONTENTS> PAN/TILT 10m
<INSTRUCTION> PLEASE CHOOSE MENU DATA BY ARROW-KEY
LOAD(F1) QUIT(F3) SAVE(F5)
Fig. 4-3-3
4.3.3. Saving the Adjustment Data
This saving procedure is recommended to keep the current
adjustment status of the camera.
8 Press the SAVE (F5) key of the computer, and the
computer will ask you for the file name.
8 Type xxxxxxxx.EV2 CC0 14CA. Give an appropriate file
name for xxxxxxxx within 8 letters, but do not use
CS854BE.
8 Press the ENTER key.
CCTV PRODUCT: CS850 EEPROM: 3
P a g e ( 1 / 1 ) N T S C
4.3.4. Loading the Adjustment Data
This loading procedure is recommended to return the
adjustment status of the camera to the factory default setting
or the setting you saved before.
8 Press the LOAD (F1) key of the computer, and the
computer will ask you for the file name.
8 Type CS854BE.EV2 or xxxxxxxx.EV2 (xxxxxxxx means
a file name you named before.) and press the ENTER
key.
4.3.5. Adjustment Procedure
3 Adjustment
Q Select the item "1. PAN/TILT POSITON-1" with the
ARROW key and press the ENTER key.
W Wait until the camera stops moving.
E When the camera stops, place the camera aiming the
white paper as shown in Fig. 4-3-2.
R Adjust the lens tilt position using the E.V.R. Adjustment
Kit so that the center line on the chart overlays with the
line on the Video Monitor as shown in Fig. 4-3-4.
Horizontal Line
T Press the ENTER key.
y Repeat w - r ,and press ENTER key.
3 Confirmation of the result
Q Turn off the power and on again.
W Move the tilt position towards the horizontal level using
the E.V.R. Adjustment Kit.
E Confirm the horizontal line stops at the center line of the
Video Monitor.
R If the horizontal line does not stop at the center line,
press ESC key, and select the item "3. TILT RE-ADJ"
with the ARROW key and press the ENTER key.
T Repeat "Adjustment" until the horizontal lines overlay
each other.
– 2-17 –
White
Paper
Center Line
Video Monitor
Fig. 4-3-4