Panasonic WV-CS850B Service Manual page 12

3. Connection and Setting up for
Adjustment
3.1. Connection
8
Fig. 3-1-1 shows the connecting diagram for the
adjustment of the WV-CS850B/CS854BE.
Personal Computer
Standard
RS-232C
CAMERA
WV-CS850B
WV-CS854BE
E.V.R.
Adjustment Kit
+12V DC
24V AC
Power Supply
Power Supply
(for WV-CS854BE)
220 - 240 V AC (for WV-CS850B)
Fig. 3-1-1
8
Connect the Underscanned Colour Video Monitor to the
Video Output Connector of the E.V.R. Adjustment Kit
through the Vectorscope using the coaxial cables.
8
Connect the Video Output Cable of the WV-
CS850B/CS854BE to the CAMERA INPUT Connector of
the E.V.R. Adjustment Kit by the coaxial cable.
8
Terminate the input terminal of the Underscanned Colour
Video Monitor with 75Ω.
8
Connect the 24V AC Power Supply Unit to the WV-
CS854B or connect the 220-240 V AC Power Supply Unit
to the WV-CS850B.
8
Connect the +12 V DC Power Supply Unit to the E.V.R.
Adjustment Kit.
8
Connect the E.V.R. Adjustment Kit to IBM PC/AT type
using the Standard Straight RS-232C cable.
8 Connect the probe of the Digital Voltmeter, Oscilloscope
or Frequency Counter at the desired Test Point in each
adjustment step.
Floppy Disk
Underscanned
Vectorscope Colour Video Monitor
75Ω
3.2. Setting Up for the Remote E.V.R
Adjustment Kit
< Remote E.V.R Adjustment Kit >
8
Fig. 3-2-1 shows the Remote E.V.R. Adjustment Kit.
Up Mode Selection
Switch Switch
Left Right
Switch Switch
NORMAL NORMAL
OPERATE OPERATE REMOTE REMOTE
SYSTEM SYSTEM
ALARM OFF ALARM OFF
Down Set
Switch Switch
< Switch Setting >
8
Referring to Fig. 3-2-2, remove four screws that secure
the Upper Cover and remove the Upper Cover.
8
Set the switch SW3 on the board to the position as shown
in Fig. 3-2-3.
SW3
8
Set the VP/STD CAMERA selection switch on the rear
panel to STD CAMERA position.
– 2-8 –
Program
Switch
VP/STD Camera Selection Switch
ALARM ALARM VP CAMERA STD. CAMERA
VIDEO
PROG PROG RESET RESET
OUT
RS232C
EVR EVR
RS232C Connector
Fig. 3-2-1
Remove four screws.
Upper Cover
Fig. 3-2-2
<SW3>
ON
1
Select switch #2 to
ON position.
Board
Fig. 3-2-3
DC12V IN
CAMERA
IN
2 3 4