Important Safety Instructions - Arris SURFboard SBR-AC1900P User Manual

Important Safety Instructions

Read This Before You Begin — When using your equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to persons, including
the following:
Read all of the instructions listed here and/or in the user manual before you operate this

device. Give particular attention to all safety precautions. Retain the instructions for
future reference.
This device must be installed and used in strict accordance with manufacturer's

instructions, as described in the user documentation that is included with the device.
Comply with all warning and caution statements in the instructions. Observe all warning

and caution symbols that are affixed to this device.
To prevent fire or shock hazard, do not expose this device to rain or moisture. The device

must not be exposed to dripping or splashing. Do not place objects filled with liquids, such
as vases, on the device.
This device was qualified under test conditions that included the use of the supplied

cables between system components. To ensure regulatory and safety compliance, use
only the provided power and interface cables and install them properly.
Different types of cord sets may be used for connections to the main POWER supply

circuit. Use only a main line cord that complies with all applicable device safety
requirements of the country of use.
Installation of this device must be in accordance with national wiring codes and conform

to local regulations.
Operate this device only from the type of power source indicated on the device's marking

label. If you are not sure of the type of power supplied to your home, consult your dealer
or local power company.
Do not overload outlets or extension cords, as this can result in a risk of fire or electric

shock. Overloaded electrical outlets, extension cords, frayed power cords, damaged or
cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire
hazard.
Route power supply cords so that they are not likely to be walked on or pinched by items

placed upon or against them. Pay particular attention to cords where they are attached to
plugs and convenience receptacles, and examine the point where they exit from the
device.
Place this device in a location that is close enough to an electrical outlet to accommodate

the length of the power cord.
Place the device to allow for easy access when disconnecting the power cord of the device

from the electrical wall outlet.
Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug

can be fully inserted with no part of the blades exposed.
Place this device on a stable surface.

STANDARD PN 365-095-28244 x.1
Copyright ARRIS Enterprises, LLC, 2016. All Rights Reserved.
SURFboard SBR-AC1900P Wi-Fi Router User Guide
Chapter 1
6