Configuring The Wireless Connection - Arris SURFboard SBR-AC1900P User Manual

4. Connect the power adapter (included) to the power connector on the back of the Wi-Fi
Router, and then connect the power adapter to an available AC outlet. Wait until the 2.4
GHz and 5 GHz LEDs on the rear panel of the Wi-Fi Router turn solid green.
5. To manage the setup of the Wi-Fi Router, you can use a second Ethernet cable (not
provided) to connect a computer to an available LAN port on the SBR-AC1900P, or you can
connect wirelessly by using the preset wireless security settings printed on the Wi-Fi
Router's label located on the bottom of the Wi-Fi Router.
6. Open a browser on the computer to access the management interface of the Wi-Fi Router,
and navigate to http://mysurfboard.local. If the webpage does not display correctly, try
another browser.
Note: If you are connecting to an existing Wi-Fi modem or gateway, you must place that
device in a 'bridged mode.' For more information, see the documentation for your Internet
access device, or contact your service provider or device manufacturer.

Configuring the Wireless Connection

The SBR-AC1900P ships with a secure SSID that is unique for every device. Wi-Fi network
information is located on the label on the bottom of the Wi-Fi Router. You should configure
the Wi-Fi Router's wireless settings.
Note: At a minimum, you should set a login password and set up wireless security. See
Setting Up a Wireless Network Connection
the wireless connection.
STANDARD PN 365-095-28244 x.1
Copyright ARRIS Enterprises, LLC, 2016. All Rights Reserved.
Chapter 3: Installing the Wi-Fi Router
(page 26) for complete instructions on configuring
SURFboard SBR-AC1900P Wi-Fi Router User Guide
22