Changing The Parameter Setting Value - Mitsubishi Electric FR-F700PJ Instruction Manual

4.1.4

Changing the parameter setting value

Changing
Change the Pr. 1 Maximum frequency setting.
example
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Changing the operation mode
Press to choose the PU operation mode.
3.
Parameter setting mode
Press to choose the parameter setting
mode.
4.
Selecting the parameter number
Turn until
5.
Displaying the setting
Press to read the present set value.
" "(120.0Hz (initial value)) appears.
6.
Changing the setting value
Turn to change the set value to
" " (60.00Hz).
7.
Parameter setting
Press to set.
 Turn
 Press
 Press
 Press
REMARKS
to
appears .................... Write disable error
appears .................... Write error during operation
appears .................... Calibration error
appears .................... Mode designation error
(For details, refer to page 298.)
 The number of digits displayed on the operation panel is four. Only the upper four digits of values can be displayed and set. If the
values to be displayed have five digits or more including decimal places, the fifth or later numerals cannot be displayed nor set.
(Example) For Pr. 1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed and second decimal place is not displayed nor set.
(Pr. 1) appears.
Flicker...Parameter setting complete!!
to read another parameter.
to show the setting again.
twice to show the next parameter.
twice to return to frequency monitor.
is displayed...Why?
Operation panel
Display
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously
appears.)
Hz
A
Hz
A
Hz
A
4
61