Mitsubishi Electric FR-F700PJ Instruction Manual page 294

(b) Method to set frequency only without adjusting gain analog value
(When changing the gain frequency from 60Hz to 50Hz)
Operation
1.
Confirm the operation status indicator and
operation mode indicator
The inverter should be at a stop.
The inverter should be in the PU operation mode
(depends on
2.
Press to choose the parameter setting
mode.
3.
Turn until
4.
Press to display
5.
Turn until
C24 (Pr.923) Frequency setting voltage gain frequency
(built-in potentiometer)
6.
Press to show the present set value.
7.
Turn to change the set value to "50.00".
8.
Press to set.
Turn
Press
Press
REMARKS
 To use the built-in frequency setting potentiometer (Pr.146 = "0") to operate at a frequency higher than 60Hz, change C24 and
C25 (Pr.923) settings. Simply changing the Pr.1 and Pr.18 settings does not enable the operation at a frequency higher than
60Hz.
 Setting of Pr. 146, C22 (Pr. 922), C23 (Pr. 922), C24 (Pr. 923), C25 (Pr. 923) can be performed from the inverter operation panel.
However, it can be performed only when the operation panel PA02 for the FR-E500 is connected.
 When setting frequency, parameter, etc. using the operation panel PA02, it is necessary to hold down the
 Past four faults are stored in the faults history when the operation panel PA02 is connected.
 All faults (E.ILF, E.IOH. E.AIE, E.CDO, E.PTC, E.SOT, E.PID, E.SAF) added to the FR-F700PJ series are displayed as E.14.
FR-E500 series operation panel (PA02) setting
).
appears.
.
appears. Turn the dial to
to read another parameter.
to return to the
twice to show the next parameter (
Flicker...Parameter setting complete!!
(Adjustment completed)
indication (step 4).
).
Display
The parameter
number read
previously appears.
C0 to C25 settings
are enabled.
Hz
A
Hz
A
Hz
A
key for 1.5s.
4
289