Mitsubishi Electric FR-F700PJ Instruction Manual page 146

Setting
Signal
Positive Negative
logic logic
57 157 IPM IPM motor control
64 164 Y64 During retry
70 170 SLEEP PID output interruption
Pulse train output
79 179 Y79
of output power
90 190 Y90 Life alarm
Fault output 3
91 191 Y91
(power-off signal)
Energy saving
92 192 Y92 average value
updated timing
Current average
93 193 Y93
value monitor signal
Maintenance timer
95 195 Y95
signal
96 196 REM Remote output
98 198 LF Alarm output
99 199 ALM Fault output
9999 — No function

Note that when the frequency setting is varied using an analog signal or
alternate ON and OFF depending on that varying speed and the timing of the varying speed due to acceleration/deceleration time setting.
(The output will not alternate ON and OFF when the acceleration/deceleration time setting is "0s".)
REMARKS
 The same function may be set to more than one terminal.
 When the function is executed, the terminal conducts at the setting of any of "0 to 99", and does not conduct at the setting of
any of "100 to 199".
NOTE
 Changing the terminal assignment using Pr.190 and Pr.192 (output terminal function selection) may affect the other
functions. Set parameters after confirming the function of each terminal.
 Do not assign signals which repeat frequent ON/OFF to A, B, and C. Otherwise, the life of the relay contact decreases.
 The common terminal for terminal RUN is terminal SE.
Function assignment of external terminal and control
Function
Output during IPM motor control.
Output during retry processing.
Output when the PID output interruption function is
executed.
Output in pulses every time the accumulated output power
of the inverter reaches the Pr.799 setting.
Output when any of the control circuit capacitor, main
circuit capacitor and inrush current limit circuit or the
cooling fan approaches the end of its service life.
Output when a fault occurs due to the internal circuit failure
or the inverter wiring mistake, etc.
Turned ON and OFF alternately every time the average
power saving is updated when the power saving monitor is
used.
Cannot be set to Pr. 192 (relay output terminal).
Average current value and maintenance timer value are
output as pulses.
The signal cannot be set in Pr. 192 A,B,C terminal function
selection .
Output when Pr. 503 rises to or above the Pr. 504 setting.
Output to the terminal when a value is set to the parameter.
Output when an alarm (fan failure or communication error
warning) occurs.
Output when a fault occurs.
The signal output is stopped when the fault is reset.
Operation
—
of the operation panel, the output of the SU (up to frequency) signal may
Refer
Related
to
Parameter
Page
Pr. 71, Pr. 80,
83
Pr. 998
Pr. 65 to
170
Pr. 69
Pr. 127 to
Pr. 134,
250
Pr. 575 to
Pr. 577
Pr. 799 149
Pr. 255 to
265
Pr. 259
— 143
Pr. 52, Pr. 54,
Pr. 158,
176
Pr. 891 to
Pr. 899
Pr. 555 to
269
Pr. 557
Pr. 503,
268
Pr. 504
Pr. 495,
148
Pr. 496
Pr. 121, 221,
Pr. 244 264
— 143
— —
4
141