Changing The Parameter Setting Value; Displaying The Set Frequency - Mitsubishi Electric FR-D720 K Series Instruction Manual

4.1.4

Changing the parameter setting value

Changing
Change the Pr. 1 Maximum frequency setting.
example
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until "
5.
Press to read the present set value.
" "(120.0Hz (initial value)) appears.
6.
Turn to change the set value to
" " (60.00Hz).
7.
Press to set.
 Turn
 Press
 Press
 Press
REMARKS
to
" " appears .................... Write disable error
" " appears .................... Write error during operation
" " appears .................... Calibration error
" " appears .................... Mode designation error
(For details, refer to page 258.)
 The number of digits displayed on the operation panel is four. Only the upper four digits of values can be displayed and set. If the
values to be displayed have five digits or more including decimal places, the fifth or later numerals cannot be displayed nor set.
(Example) For Pr. 1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed and second decimal place is not displayed nor set.
4.1.5

Displaying the set frequency

Press the setting dial (
show the set frequency.
" (Pr. 1) appears.
to read another parameter.
to show the setting again.
twice to show the next parameter.
twice to return to frequency monitor.
is displayed...Why?
) in the PU operation mode or in the External/PU combined operation mode 1 (Pr.79 = "3") to
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously
appears.)
Alternating...Parameter setting complete.
Operation panel
Display
4
59