Cadillac SRX 2010 Owner's Manual page 326

srx.book Page 30 Monday, June 8, 2009 8:28 AM
9-30
Up-level Vehicle
2. Locate the aim point at the center
inner projector condensing lens
of the low-beam headlamp (not
the outer lens).
3. Measure the distance from the
ground to the aim dot on the
low-beam headlamp. Record the
distance.
4. At the wall measure from the
ground upward (A) to the
recorded distance from Step 3
and mark it.
5. Draw or tape a horizontal line (B)
on the wall the width of the
vehicle at the height of the mark
in Step 4.
Notice: Do not cover a headlamp
to improve beam cut-off when
aiming. Covering a headlamp may
cause excessive heat build-up
which may cause damage to the
headlamp.
6. Turn on the low-beam headlamps
and place a piece of cardboard or
equivalent in front of the
headlamp not being adjusted.
This allows only the beam of light
from the headlamp being
adjusted to be seen on the flat
surface.
7. Locate the vertical headlamp
aiming screws, which are under
the hood near each headlamp
assembly.