Cadillac SRX 2010 Owner's Manual page 10

srx.book Page 6 Monday, June 8, 2009 8:28 AM
1-6
3. Place the new transmitter into the
transmitter pocket. The
transmitter pocket is inside the
center console storage area
located between the driver and
front passenger seats. The
storage area will need to be
opened and the storage tray lifted
up to access the transmitter
pocket.
4. Press the ignition. When the
transmitter is learned the DIC
display will show that it is ready to
program the next transmitter.
5. Remove the transmitter from the
transmitter pocket and press
on the transmitter.
To program additional
transmitters, repeat Steps 3
through 5.
When all additional transmitters
are programmed, press and hold
the ignition for 5 seconds to exit
programming mode.
Programming without a
Recognized Transmitter (Keyless
Access Vehicles Only)
If there are no currently recognized
transmitters available, follow this
procedure to program up to eight
transmitters. This procedure will take
approximately 30 minutes to
complete. The vehicle must be off
and all of the transmitters you wish to
program must be with you.
1. Insert the vehicle key of the
transmitter into the key lock
cylinder located on the outside of
the driver door and turn the key to
the unlock position five times
within ten seconds.
The Driver Information Center
K (DIC) displays "Remote Learn
Pending, Please Wait".
2. Wait for ten minutes until the DIC
displays "Press Engine Start
Button To Learn" and then press
the ignition.
The DIC displays will again show
"Remote Learn Pending, Please
Wait".
3. Repeat Step 2 two additional
times. After the third time all
previously known transmitters will
no longer work with the vehicle.
Remaining transmitters can be
relearned during the next steps.
The DIC display should now
show "Ready For Remote # 1".