Cadillac SRX 2010 Owner's Manual page 272

srx.book Page 36 Monday, June 8, 2009 8:28 AM
8-36
T
(On/Off): Press to turn the
system on and off.
+ RES (Resume/Accelerate): Press
to make the vehicle accelerate or
resume to a previously set speed.
SET − (Set/Coast): Press to set the
speed or make the vehicle slow
down.
[ (Cancel): Press to cancel cruise
control without erasing the set speed
from memory.
Setting Cruise Control
Cruise control will not work if the
parking brake is set, or if the master
cylinder brake fluid level is low.
The cruise control light on the
instrument panel cluster comes on
after the cruise control has been set
to the desired speed.
{
WARNING
If you leave your cruise control on
when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
You could be startled and even
lose control. Keep the cruise
control switch off until you want to
use cruise control.
T
1. Press .
2. Get up to the desired speed.
3. Press the SET− button located on
the steering wheel and release it.
4. Take your foot off the accelerator.
Resuming a Set Speed
If the brakes are applied while the
cruise control is at a set speed, the
cruise control disengages. But it
does not need to be reset.
Once the vehicle reaches about
40 km/h (25 mph) or more, press the
+RES button on the steering wheel.
The vehicle returns to the speed
selected previously and stays there.
Increasing Speed While Using
Cruise Control
To increase the cruise speed while
using cruise control:
• Press and hold the +RES button
on the steering wheel until the
new desired speed is reached,
and then release the button.
• To increase vehicle speed in small
increments, press the +RES
button. Each time this is done, the
vehicle goes about 1.6 km/h
(1 mph) faster.