Arp Midi Out (Arpeggio Midi Out); Midi Sync; Receive (Receive Sequencer Control); Transmit (Transmit Sequencer Control) - Yamaha Montage 7 Reference Manual

Reference
Performance

Arp MIDI Out (Arpeggio MIDI Out)

Determines whether to output MIDI data of Arpeggio playback or not.
Settings: Off, On

MIDI Sync

You can set various parameters related to MIDI clock and synchronization here.
Determines whether Arpeggio/Motion Sequencer/Song playback will be synchronized to the instrument's
internal clock, an external MIDI clock, or the Audio signal input from the A/D INPUT [L/MONO]/[R] jacks.
Settings:
Internal, MIDI, A/D In
Internal: Synchronization to internal clock. You can use this setting when this tone generator is to be used alone or
as the master clock source for other equipment.
MIDI:
Synchronization to a MIDI clock received from an external MIDI instrument via MIDI. Use this setting when the
external sequencer is to be used as master.
A/D In: Synchronization to the tempo of the Audio signal received via the A/D INPUT [L/MONO]/[R] jacks.
Clock Out
Determines whether MIDI clock messages will be transmitted via MIDI or not.
Settings:
Off, On

Receive (Receive Sequencer Control)

Determines whether the Sequencer Control signals – start and stop of Song – will be received via MIDI or
not.
Settings: Off, On

Transmit (Transmit Sequencer Control)

Determines whether the Sequencer Control signals – start and stop of Song – will be transmitted to MIDI or
not.
Settings: Off, On
Controller Reset
Determines the status of the controllers (Modulation Wheel, Aftertouch, Foot Controller, Breath Controller,
Knobs, etc.) when switching between Performances. When this is set to "Hold," the controllers are kept at
the current setting. When this is set to "Reset," the controllers are reset to the default states (below).
Settings: Hold, Reset
If you select "reset," the controllers will be reset to the following states/positions:
Pitch Bend
Modulation Wheel
Aftertouch
Foot Controller
Footswitch
Ribbon Controller
Breath Controller
Expression
Assignable Switches 1 and 2
Motion Sequencer Hold
Each Lane of Motion Sequencer
FS Assign (Footswitch Assign Control Number)
Determines the Control Change number generated by using the Footswitch connected to the FOOT
SWITCH [ASSIGNABLE] jack. Even when the instrument receives MIDI message with the same Control
Change Number specified here from the external equipment, the instrument assumes that the message is
generated by using the Footswitch.
Settings:
Off, 1 – 95, Arp SW, MS SW, Play/Stop, Live Set+, Live Set-, Oct Reset
MONTAGE Reference Manual
Edit Search
Center
Minimum
Minimum
Maximum
Off
Center
Maximum
Maximum
Off
Off
0 (minimum) when Lane Motion Sequencer
Polarity is set to "Unipolar"
64 (center) when Lane Motion Sequencer
Polarity is set to "Bipolar"
Utility Live Set
Uitlity
Settings
Sound
Quick Setup
Audio I/O
MIDI I/O
Advanced
System
Contents
Load
Store / Save
Data Utility
Tempo Settings
Effect Switch
170