Yamaha Montage 7 Reference Manual page 143

Reference
Performance
Coarse (Coarse Tune)
Determines the pitch of each Operator.
Settings: When "Freq Mode" is set to "Ratio": 0 – 31
When "Freq Mode" is set to "Fixed": 0 – 21
Fine (Fine Tune)
Determines the fine tuning for the pitch of each Operator.
Settings: When "Freq Mode" is set to "Ratio": 0 – 99
When "Freq Mode" is set to "Fixed": 0 – 127
Detune
Sets the Output Pitch of the Operator slightly higher or lower.
Even if the same parameter value is set for both "Coarse Tune" and "Fine Tune," the Detune lets you
slightly raise or lower the pitch of each Operator, allowing you to add an extra dimension to the sound and
enhance the spatial characteristics.
Settings:
-15 – +15
Pitch/Key (Pitch Key Follow Sensitivity)
Determines the sensitivity of the Key Follow effect (the degree depending on their position or octave
range). This is available only when "Freq Mode" is set to "Fixed."
Settings: 0 – 99
0: All notes are the same pitch specified by Coarse and Fine.
99:
Adjacent notes are pitched one semitone apart.
Level
From the Level display you can make all the volume settings for the Operator.
[PERFORMANCE]  [EDIT]  Part selection  Operator selection  [Level]
Operation
The full names of the available parameters are shown in the chart below, as they appear in the display.
Hold
Time Hold Time
Level –
Settings:
Time: 0 – 99
Level: 0 – 99
MONTAGE Reference Manual
Edit
Normal Part (AWM2)
Attack Decay1
Attack Time Decay1 Time
Attack Level Decay1 Level
Search
Drum Part Normal Part (FM-X)
Decay2 Release
Decay2 Time Release Time
Decay2 Level Release (Hold) Level
Utility Live Set
Common/Audio
Normal Part (FM-X) Edit
Common
Part Settings
General
Algorithm
Zone Settings
Zone Transmit
Pitch / Filter
Pitch
PEG/Scale
Filter Type
Filter EG
Filter Scale
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
2nd LFO
Control Assign
Receive SW
Operator
Form / Freq
Level
143