List Of Rs-232C Commands - Pioneer PDP-R04E Service Manual

5

6.8 LIST OF RS-232C COMMANDS

RS-232C commands can be used in Service Factory mode.
Before using RS-232C commands, it is necessary to change the factory presetting. See "6.3. USING RS-232C COMMANDS."
Command
A
ABL Adjusting power consumption
B
BCP Transmitting the backup data to the DIGITAL Assy
BR0 UART setting: SR+ (9600 BPS)
BR1 UART setting: RS-232C (1200 BPS)
BR2 UART setting: RS-232C (2400 BPS)
BR3 UART setting: RS-232C (4800 BPS)
BR4 UART setting: RS-232C (9600 BPS)
BR5 UART setting: RS-232C (19200 BPS)
BR6 UART setting: RS-232C (38400 BPS)
BSL Adjusting side mask B
BVH Setting the power supply for the BSD antenna to 15 V
BVL Setting the power supply for the BSD antenna to 11 V
BVM Setting the power supply for the BSD antenna to 0 V
BYG BY GAIN
C
CNG Clearing MR NG information
CPC Clearing the power-on counter
CPD Clearing power-down information
CPM Clearing the pulse meter
CSD Clearing shutdown information
D
DIY Turning on the on-screen display
DIN Turning off the on-screen display
DOF Erasing the currently displayed indications
DRF Turning off the power for the drive system
DRN Turning on the power for the drive system
DW* Decreasing the adjustment value by *
E
EWN Prohibiting writing of EDID data
EWY Permitting writing of EDID data
F
F50 Video 50-Hz sequence
F60 Video 60-Hz sequence
F61 PC 60-Hz sequence
F70 PC 70-Hz sequence
F72 Video 72-Hz sequence
F75 Video 75-Hz sequence
FAJ Determining the adjustment values for the unit
FAN Turning Service Factory mode off
G
GAJ Obtaining the adjustment values for the panel
GMM Switching the gamma levels
GNG Obtaining NG data of the MR
GNM Obtaining the serial No. of the MR
GPC Obtaining the P ON COUNTER value
GPD Obtaining power-down information
GPR Obtaining the PANEL REVISE data
GPM Obtaining the PULSE METER data
GPW Obtaining the PANEL W/B data
GS1 Obtaining the version data for each device
GS2 Obtaining data on various operations
GSD Obtaining shutdown information
GSL Adjusting side mask G
5
6
Operation
6
7
Any RS-232C command to the Media Receiver becomes disabled as soon as this
command is issued.
While the DIY command is in force, the duration of on-screen display is unlimited.
On-screen display is prohibited.
If another command is received by the Media Receiver, an on-screen display is
displayed.
*: 1-9, 0 (0 means 10), or F (making the adjustment value the minimum)
The GUI equivalent to that usually displayed when the power is turned on is displayed.
The GET-group commands are effective at any time, including during Standby mode.
Setting value: 000-007
PDP-R04E
7
8
Remarks
8
A
B
C
D
E
F
121