List Of Rs-232C Commands - Pioneer PDP-R06G Service Manual

1

6.4 LIST OF RS-232C COMMANDS

RS-232C commands can be used in Service Factory mode. Before using RS-232C commands, it is necessary to change the factory
A
presetting.
Also the RS-232C commands for the panel is not listed. Please refer to panle's service manual.
Command
B
BSL Adjust side mask B
C
CNG Clearing MR NG information
CHR Clearing MR Hour meter
D
DW* Decreasing the adjustment value by*
B
F
FAN Turning Service Factory mode off.
FAY Turning Service Factory mode on.
FST Final Set Up
G
GSL Adjusting side mask G
I
INA Selection of tuner for terrestrial analog signals.
C
INC*** Selection of tuner for terrestrial digital signals.
INH Selection of SD card/PCMCIA card
INPS01 Input selection: input 1
INPS02 Input selection: input 2
INPS03 Input selection: input 3
INPS04 Input selection: input 4
INPS05 Input selection: input 5
O
OSDS00 Turning On-Screen Display off
D
OSDS01 Turning On-Screen Display on
P
POF Turning the power off.
PON Turning the power on.
Q
QS1 Obtaining the version data for each device.
QS6 Obtaining the any version.
QMT Obtaining the MR temperature information.
QNG Obtaining NG data of the MR.
R
RSL Adjustment od side mask R
E
U
UP* Increasing the adjustment value by *
Z
ZME Initializing of the EEPROM video data
F
38
1
2
Operation
PDP-R06G
2
3
Remarks
*:1-9, 0 (0 means 10), F (making the adjustment value the minimum)
Prohibit On-Screen Display.
Permit On-Screen Display.
*:1-9, 0 (0 means 10), F (making the adjustment value the maximum)
3
4
4