Copying From An External Device; Manual Recording - Panasonic DMR-EZ48V Operating Instructions Manual

Copying from an external device

Manual recording

[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW] [VHS]
e.g., Connecting to the AV2 terminal on the front
You can also connect to the AV1 input terminals on the rear.
≥Turn off the unit and other video equipment before connecting.
EJECT
AV2 IN IN 2 S VIDEO VIDEO S VIDEO VIDEO L L /MONO AUDIO R /MONO AUDIO R
This unit
AV2 IN S VIDEO VIDEO L/MONO - AUDIO- R
Yellow White Red
S Video
Audio/Video
§
cable
cable
Other video equipment
Connect to Audio/Video output terminals.
If the audio output of the other equipment is monaural
Connect to L/MONO on the AV2 input terminals at the front.
§
The S VIDEO terminal achieves a more vivid picture than the
VIDEO terminal.
About the aspect when recording a programme (➡ 23)
Preparation
≥Press [DRIVE SELECT] to select the DVD or VHS drive.
≥Insert a disc or video cassette with enough remaining blank space
(➡ 14).
≥Press [REC MODE] to select the recording mode.
≥To reduce noise in input from a video cassette recorder, set "Copy
NR" to "On" in the on-screen menu (➡ 54).
≥When recording bilingual programmes (➡ 23, Selecting Audio for
Recording)
≥When the output signal from the external device is NTSC, change
the "TV System" to "NTSC" in the Setup menu (➡ 62).
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
≥[RAM] Release protection (➡ 55).
≥This unit cannot record NTSC signals to discs that already have
PAL signal recordings.
OPEN/CLOSE
DRIVE SELECT CH CH REC
COPYING COPYING
1
While stopped
Press [INPUT SELECT] to select the
input channel for the equipment you
have connected.
e.g., If you have connected to AV2 input terminals, select "A2".
Recording to DVD
Follow the above step 1.
2
Start play on the other equipment.
3
When you want to start recording
Press [¥ REC].
Recording starts.
≥Using Flexible Recording (➡ 26), you can record the content
of a video cassette (approx. 1–8 hours) to a 4.7 GB disc with
the best possible quality of recording without wasting disc
space.
Recording to VHS
Follow the above step 1.
2
Press [1] (PLAY).
≥Start playing the video cassette and find the recording start
point.
3
Press [;] and then press [¥ REC].
≥Put the unit in recording standby mode.
4
Start play on the external device.
5
Press [;] at the point where you want
to start recording.
To skip unwanted parts
Press [;] to pause recording. (Press again to restart recording.)
To stop recording
Press [∫].
Almost all videos and DVD-Video on sale have been treated
to prevent illegal copying. Any software that has been so
treated cannot be recorded using this unit.
[Note]
≥If it becomes time for a timer recording to start while copying, the
recording will start and the copying will stop.
≥If video is copied from another piece of equipment to this unit, then
the video quality will be degraded.
RQT9127
27