Panasonic DMR-EZ48V Operating Instructions Manual page 49

5
Set the time limit.
≥If you are not going to change the recording time, press [4]
and skip to step 6.
∫To change the setting
1 Make sure "Copy Time" is selected and press [1].
2 Make sure "Time Setting" is selected and press [OK].
≥Setting the unit to copy all the content on the video cassette
3 Press [3, 4] to select "Off" and press [OK].
4 Press [2].
5 Press [4].
≥Setting the copying time
3 Press [3, 4] to select "On" and press [OK].
4 Press [4] to select "Copy Time" and press [OK].
5 Press [2, 1] to select "Hour" and "Min." and press
[3, 4] to set the recording time and then press [OK].
≥You can also set the time with the numbered buttons.
≥Maximum recording time is 8 hours.
6 Press [2].
7 Press [4].
6
Make sure "Start Copying" is selected
and press [OK].
≥The confirmation screen appears.
7
Press [2, 1] to select "Yes" and then
press [OK].
[-R] [-R]DL] [-RW‹V›] [+R] [+R]DL]
Press [2, 1] to select "Copy & Finalise" or
"Copy Only" and then press [OK].
≥Copying starts.
≥Copying is automatically stopped when the tape reaches the
end, the remaining capacity of the disc is filled.
≥If "Copy & Finalise" is selected;
After finalising, the disc becomes play-only and you can
play them on other DVD equipment.
However, you can no longer record or edit.
≥Finalising will not start if copying is not completed (e.g.,
due to shortage of remaining disc space).
∫ To stop copying in the middle (process)
Press and hold [RETURN] for about 3 seconds or more.
≥However you cannot stop finalise after it has started.
To return to the previous screen
Press [RETURN].
OK
RETURN
Press OK to start copying.
OK
Finalising is to enable the disc to be played on
other DVD players.
∫ About FR mode
When "Time Setting" is set to "Off" in step 5 above:
≥The recording mode is automatically selected by estimating the
remaining capacity of the disc for copying of only the recorded
parts in the video cassette (unrecorded parts will not be
recorded).
≥When you press [OK] to start copy, the tape is automatically
fast-forwarded to the end and then fast-rewound to the
beginning before the copying is actually started. It may take
time to start copy. If the remaining capacity of the disc is
insufficient, the copying will be stopped in the middle.
≥The recording is divided into titles every time the tape index
signals are detected.
When "Time Setting" is set to "On" in step 5 above:
≥The recording mode is automatically determined by estimating
the remaining capacity of the disc for copying of the contents
equivalent to the recording time set from the start point of the
copying on the video cassette (unrecorded parts will also be
recorded).
≥The recording is not divided into titles.
RQT9127
49