Recording From An External Device; Recording From A Vcr, Etc - Panasonic Diga DMR-EX98VEB Operating Instructions Manual

Hide thumbs Also See for Diga DMR-EX98VEB:
Table of Contents

Advertisement

Recording from an External Device

Recording from a VCR, etc.

Connect cables while both the unit and the external
device are turned off.
Front of the unit
You can get a
sharper, clearer
picture by
connecting with
an S Video
cable instead of
the yellow video
cable.
If the audio output of the external device is monaural, connect to
L/MONO on the AV3 input terminals at the front.
Preparation:
Turn on the unit.
If the disc is protected, release protection
RAM
(➔ 76).
Ensure accidental erasure tab is intact.
VHS
When the output signal from the external device is
NTSC, change the "TV System" to "NTSC" in the
Setup menu (➔ 82).
This unit cannot record NTSC signals to discs that
already have PAL signal recordings. (However, both
types of programmes can be recorded onto the HDD.)
To reduce noise in input from a video cassette
recorder, set "Copy NR" to "On" in the on-screen
display (➔ 75).
If you selected the DVD or VHS drive, insert a
disc or video cassette with enough remaining
blank space (➔ 89).
mode (➔ 28).
your external device is connected.
Front panel inputs are AV3.
32
Downloaded From Disc-Player.com Panasonic Manuals
RQT9089
HDD
DVD
SD
VHS
Yellow White Red
S Video cable
to select the HDD, DVD or
VHS drive.
to select the recording
to select the input where
Recording to HDD or DVD
HDD RAM -R -RW(V) +R +RW
Perform steps
Start play on the external device.
start recording to the disc.
Recording to VHS
VHS
Perform steps
point at which you want to start
Audio/Video
cable
recording from.
standby.
Start play on the external device.
8
point you desire.
Tips
You can also connect to the AV2 on the rear.
HDD RAM -R -RW(V) +R +RW
Using Flexible Recording (➔ 30), you can record the content of a
video cassette (approx. 1–8 hours) to a 4.7 GB disc with the best
possible quality of recording without wasting disc space.
To skip unwanted parts
Press [ h PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [ g STOP].
The confirmation screen appears. Press [OK].
Notes
When timer recording starts while recording from an external
device, timer recording takes priority and recording from the
external device stops.
If video is copied from another piece of equipment to this unit, then
the video quality will be degraded.
Almost all videos and DVD-Video on sale have been treated to
prevent illegal copying. Any software that has been so treated
cannot be recorded using this unit.
(➔ left).
at the point you want to
(➔ left).
to bring the tape to the
when you reach that point.
to put the unit in recording
to start recording at the

Advertisement

Table of Contents
loading

Table of Contents