Out-Of-Box Ca Menu Options - Motorola CA50 Developer & User Manual

Out-of-Box CA Menu Options

Table 4-6 lists the out-of-box menus available on the CA Menu when the device is powered on. Use the left and
right soft keys on the device to highlight menu options and press the Scan/Select (S) key to launch the highlighted
option.
CA Menu Options
Table 4-6
Menu
Rapid Deployment
Programs
Note: There are several out-of-box programs on the CA50 when the device is powered on. The programs listed below are
highlights.
UCA Client Application
ScanSamp
Prior to use, the CA50 device must be configured. The Rapid Deployment client facilitates
software downloads to the CA50 client.
For detailed information about the Rapid Deployment Client, see
Deployment.
Invokes the UCA client application which attempts to connect to the UCA server.
ScanSamp (scan sample application) prompts the user to scan a bar code and the scanned data
displays. Scroll up and down to display all available data. Press Scan/Select again to scan
another bar code, or press the right soft key to exit and return to the previous window.
Example of scanned data displayed:
Data: 65830923843078; Type: 0x32; Source: SCN:UPCA; Time: 00:00:22.
This application can also be used to test the laser if it does not emit when the Scan/Select is
pressed.
To scan a bar code:
On the CA Menu, select Programs > ScanSamp.
1.
Press Scan/Select to launch the ScanSamp test application.
2.
Aim the scan window at a bar code and press Scan/Select. The laser emits, the lower
3.
left of screen displays Acquiring, and the red LED remains on until the data is acquired or
the laser times out.
View scan data on the display. On a good decode, the green LED lights for approximately
4.
3 seconds and the scan data displays. Use the down arrow to scroll through the
information.
See Troubleshooting the CA50 Device on page 14-11
problems and solutions.
CA50 Modes of Operation 4 - 19
Description
Appendix F, Rapid
for information about scanning and laser